Commit 6881c1b6 authored by David Brownell's avatar David Brownell
Browse files

target.cfg: (re)move some bogus reset_config lines



General rule, this is all board-specific and doesn't belong
in target config files.  Some of these were just cosmetic.
Signed-off-by: default avatarDavid Brownell <dbrownell@users.sourceforge.net>
parent 85944d41
source [find target/at91sam3u4e.cfg]
reset_config srst_only
## -*- tcl -*-
##
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
......@@ -21,14 +17,9 @@ if { [info exists CPUTAPID] } {
set _CPUTAPID 0x3f0f0f0f
}
jtag_nsrst_delay 200
jtag_ntrst_delay 200
# This is for the case that TRST/SRST is not wired on your JTAG adaptor.
# Don't really need them anyways.
reset_config none
## JTAG scan chain
#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
......
......@@ -35,8 +35,6 @@ target create $_TARGETNAME cortex_m3 -endian $_ENDIAN -chain-position $_TARGETNA
# 16K is plenty, the smallest chip has this much
$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size 16384 -work-area-backup 0
reset_config srst_only
$_TARGETNAME configure -event gdb-flash-erase-start {
halt
}
......@@ -21,7 +21,6 @@ if { [info exists CPUTAPID] } {
}
#use combined on interfaces or targets that can't set TRST/SRST separately
#reset_config trst_and_srst srst_pulls_trst
reset_config trst_and_srst srst_pulls_trst
#jtag scan chain
......
......@@ -22,7 +22,6 @@ if { [info exists CPUTAPID] } {
jtag_khz 10
#use combined on interfaces or targets that can't set TRST/SRST separately
#reset_config trst_and_srst srst_pulls_trst
reset_config trst_and_srst srst_pulls_trst
#jtag scan chain
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment